How to Remove the Governor on a Predator 212

Step-by-step guide to safely remove the RPM limiter from your Predator 212 engine.

intermediate~60 minutes

Steps

Disconnect all cables, fuel lines, and mounting bolts. Carefully lift the engine out and place it on a clean work surface.

Remove the bolts holding the side cover. The governor assembly is located behind this cover.

The governor gear is a small gear connected to the crankshaft. It will be visible once the side cover is removed.

Carefully remove the governor gear. You may need to remove the connecting rod cap to access it fully.

⚠️ Warning: Be careful not to damage the crankshaft or connecting rod during removal.

Remove the external governor linkage that connects to the carburetor. This prevents the throttle from being limited.

Reinstall the side cover and all components. Make sure all bolts are properly torqued.

For a cleaner installation, use a governor delete kit that includes a block-off plate and proper hardware.

Governor Delete Kit

governor delete