← Back to Guides
Billet Flywheel Installation
Critical safety upgrade for high-RPM builds. A billet flywheel prevents catastrophic failure.
advanced~90 minutes
Steps
1
Remove the Stock Flywheel
Remove the flywheel nut and use a flywheel puller to remove the stock cast flywheel.
⚠️ Warning: NEVER use a hammer or pry bar on the flywheel. Always use a proper puller.
2
Inspect the Crankshaft
Check the crankshaft keyway for damage. Replace the key if necessary.
3
Install Billet Flywheel
Slide the billet flywheel onto the crankshaft, aligning the keyway. Install the flywheel nut.
4
Torque the Flywheel Nut
Torque the flywheel nut to manufacturer specifications (typically 50-60 ft-lbs).
⚠️ Warning: Proper torque is critical for safety. An improperly torqued flywheel can come loose at high RPM.
5
Install Coil and Timing
Reinstall the ignition coil and set the timing gap (typically 0.010-0.012").